Using same soundcard among users with PulseAudio not in system mode

Sound on GNU/Linux never have been convenient. Right now, de facto standard is PulseAudio: yeah, made by the same people that does this nightmare of systemd. When it works it is better than just ALSA  (Advanced Linux Sound Architecture). When it doesn’t, you’re in for a headache.

Anyway, I had this situation where I wanted user whatever to be able to use the soundcard. But the soundcard was blocked and reserved by PulseAudio started by my regular user account.

First option is to make PulseAudio work as a system daemon. UNIX-style option. Quite obviously, that would be too easy to implement for these systemd people. So they implemented the option altogether advising not to use it. I did not care about the advice, though, so I tried. And then I understood why, while advising not to use it, they said they would not be accountable for problems using it. Because it is utter trash, unreliable, giving out error endless messages and, in the end, not working at all.

 So the system mode is a no-go, in the short run and definitely not in the long run either.

Alternate option is to open PulseAudio through the loopback network device. To do so, in /etc/pulse/default.pa add the TCP module with 127.0.0.1:

load-module module-native-protocol-tcp auth-ip-acl=127.0.0.1

Obviously, by default tcpwrapper will refuse access, so you have also to add the relevant counterpart in /etc/hosts.allow :

pulseaudio-native: 127.0.0.1

From now on, after restarting PulseAudio, you should be able to access it through any user (in audio group).

Update: some comments on reddit made me think there has been a misunderstanding on the scope of this post. It is not to describe inner workings of audio on common GNU/Linux systems with PulseAudio. The following does and almost perfectly explain why I did not bother get specific on the topic :